Category Archives: Uncategorized

Analogue Electronics Lab 12 1. VALUE OF R1: 2= 1.1*R*0.00001 =181,818k https://www.multisim.com/content/TeeUNFiLTKju7WfBmYYMHm/wc-monostable-multivibrator/open/ 2. Jimmy Kavetas’ Final Project looks like the only previous final project that used a VCA envelope filter(555 timer involved) and a distortion to make his distortion pedal. So Jimmy uses a 555 timer to run his distortion circuit and since its switchingContinue reading “Lab 12”

Analogue Electronics Lab 11 1) Here are the 3 pedals that I looked at:  https://www.alexanderpedals.com/shop/space-race 1a) The pedals I picked were primarily visually appealing to me. But each pedal I picked is from a different type of effect. The “holy wahcamoly” is a wah/gate effect, “golem” is a drive effect, and “space race” is aContinue reading “Lab 11”

Analogue Electronics Lab 10  https://www.multisim.com/content/RLrXiCkiNoJmAnFafooR7Z/analogue-electronics-lab-10/open/

Analogue Electronics Lab 9 A B Yes With this circuit, if you turn the crossfader all the way to one side you’ll hear (Distortion).  If you turn the crossfader all the way to the other side you’ll hear (undistorted, clean audio). If you turn the potentiometer to its halfway point, you’ll hear a mixture ofContinue reading “Lab 9”

Analogue Electronics Lab 8 1) With the oscillator we’re studying the comparator outputs a (Square) wave and the integrator outputs a (Triangle) wave. 2) With an integrator, if Vin is positive the output voltage ramps DOWN (up/down). If Vin is negative the output voltage ramps UP (up/down). 3) With a comparator, if the op amp’s +Continue reading “Lab 8”

Analogue Electronics Lab 6 Part(s) 1-2: RC Lowpass filter: RC Highpass filter: Part(s) 3-4: Switch Lowpass/Highpass Circuit: Part 5(Final Project): a) Describe in a few sentences a Final Project you think you could build, which would be interesting to you, which appears to be at about the skill level of the analog students from lastContinue reading “Lab 6”

Analogue Electronics Lab 5 Adding a resistor and a capacitor to the input and output of the circuit prevents current from flowing the wrong way if you make a mistake, which could cause a fire or fry equipment/start a fire etc. Gain = (1 + 10k/10k)Gain = 2 Pot turned to max value: Gain =Continue reading “Lab 5”

2. The “Horizontal position” knob should be set facing vertically straight up, otherwise the image will be offset to the left or right. The “Vertical Position” knobs need to be set facing vertically straight up, if they arent the image will be offset on the y-axis. The “Mode” switch on the scope should be setContinue reading “Lab 4”

Analogue Electronics Lab 3 Part 1) Soldering Part 1a) How to use the Soldering Iron First, turn on the soldering iron, and set the temperture inbetween 4 and 5 on the knob. Always hold the soldering iron by the padded black handle, DO NOT touch any medal portion of the iron above the balck handle(itContinue reading “Lab 3”